Buy Fostex F A – Alnico/Fullrange online at » € ✓ Your online hifi specialist retailer for Fullrange. When I heard Fostex FA alnico full range driver first time I realized its great potential. Problems associated with this driver IMHO have been. Fostex 8” FULL RANGE Alnico magnet Foam surround 8 ohm impedance Frequency response from 30Hz to 20kHz 90 dB sensitivity Flange X mm .
|Published (Last):||14 November 2007|
|PDF File Size:||10.89 Mb|
|ePub File Size:||4.20 Mb|
|Price:||Free* [*Free Regsitration Required]|
Bemopti Full Member Posts: Compared to multi-driver speakers the sound is much more coherent but admittedly lacks a bit extension at each end compared to many of the more elaborate designs.
The dedicated room will allow for nearfield listening with lots of clear space around, proper proportions, isolated power, etc.
You may like one of these similar items: Always a plus, not that I really understand what she means by that. A few more details: Mark in Canada Logged Print Pages: I patched it up and it’s visible only under certain angle. Bob believes in flat frequency response which the design and fiber fill allows for and he has also provided a baffle step compensation circuit.
As you may see I am selling these loudspeakers for fraction of its price. What is the lowest powered tubed amp you have used with these speakers? The sound is very coherent and easy to listen too.
RE: Fostex FA revisit – Steyr – High Efficiency Speaker Asylum
Martin King’s mass loaded transmission designs have been univerally praised. Please note that due to current room and domestic restraints the speakers spend most their time almost tight against the walls of my 11 ft x 19 ft x 8 ft room with CD storage cabinet and equipment between them. For vocal and fostes music, the Jordan pipe is pretty hard to beat in any way at any cost. As I go through my collection I continue to find new detail or deeper bass than I remembered.
Bemo, We tried a 3 wpc EL34 amp and it did O. Good luck, Mark in Canada. I bought the FA drivers from Madisound last spring. I just put an order into CSS for a pair of their little 4. I’ve listened to I. Very promising they seem to be Home Marketplace Speakers Full-Range. I have all fosted in Deltacad. The amount of bass wrung from this design is hard to square with what’s going on. And the bass imaging should also go away.
Fostex F200A 8″ Full Range with Alnico magnet
With a driver of this size f200z f3 this low the MLTL can be designed to emulate an infinite baffle complete removal of the backwave but with dampening characteristics to provide higher efficiency. Wifey mentioned the other day that they were sounding good. In room on-axis response is essentially 25 — 20, Hz, with peaks reaching dB with 80 wpc inputs in a 2, cubic foot room without a whizzer.
Now if I can squeeze a small system into the master bedroom, it’d be the R200a. So far, my favorite single driver is the pm2a Medallions, but I really can’t afford the drivers. I did some very quick measurements using a RS spl meter and Stereophile test CDs a few weeks ago, but came to no real conclusion as I figure that they’re still breaking in and even with moving furniture around the setup was still less than dostex.
Last weekend a couple of friends from the Decware forum came over with some of their stuff and spent the day. The speakers are 48 inches tall, 14 inches wide, and 16 inches deep, with the driver centered 33 inches above the floor.
Fostex F200A fullrange loudspeaker (pair) Reduced Again [Expired]
In the end, give them an ear if you can, but buy what turns your crank, just fostx those speakers do! The cabinet itself must be inert. Sound Anchor 3 post stands are de-coupling speakers from the floor. JLM, I can totally understand not wanting to pop for pricey gear, if it won’t do the trick.
All I can say is that digital amps with singles are a conversion on the road to Damascus for me. I’ll have to take a look. Speaker with Sound Anchor stand: But the undynamic, inefficient behavior of the speakers is disturbing.
Single driver speakers rule. The RX-ES1 is 5. They evidently take far longer than about any other speaker out there.
Mark, This set-up will be a nearly no compromise system, so I don’t want just a great for the price solution, but a near great at any price solution or great at any reasonable price solution. BTW Bob used very little stuffing just enough to even out the frequency responsein fact the back fold of the line has no stuffing at all.
Maybe one of these days I’ll try a Fostex project There is a good review of your cabinet with the Lowther DX I believe on www. And dynamics seem to have improved as well. If he builds more he wouldn’t finish the back side around the tube mouth to much of a PIA.
It must emulate as much as possible the single point source ideal.
With the 12 wpc Torii satisfying background levels start at 8: