Ximi Elga


LM LM – Power Operational Amplifier, Package: to , Pin Nb=5. The is a monolithic power operational amplifier featuring wide bandwidth and low. DESCRIPTION. The L is a monolithic integrated circuit in Pen- tawatt® package, intended for use as power oper- ational amplifier in a wide range of. Texas Instruments LM Series Operational Amplifiers – Op Amps are available at Mouser Electronics. Mouser offers inventory, pricing, & datasheets for Texas.

Author: Telar Nikora
Country: Zimbabwe
Language: English (Spanish)
Genre: Life
Published (Last): 6 November 2004
Pages: 242
PDF File Size: 5.62 Mb
ePub File Size: 1.81 Mb
ISBN: 915-5-21934-295-5
Downloads: 15430
Price: Free* [*Free Regsitration Required]
Uploader: Moshicage

I B vs Supply Voltage. National does not assume any responsibility for use of any circuitry described, dataaheet circuit patent licenses are implied and National reserves the right at any time without notice to change said circuitry and specifications.

For operation at higher tab temperatures, the LM must be derated based on a maximum junction temperature of ? When driving nonlinear reactive loads such as motors or.

THD vs Power Output.

Power Operational Amplifier

Most power amplifiers do not drive highly capacitive loads. It has a tendency to oscillate although sometimes to works okay, just often enough to give me hope that I might be close.


I’m using an LM datasheet because I have it at hand, and it’s rated for the voltage and current. The LM is designed to be stable when operated at a.

If the die tempera. High performance power op amp. How do I calculate noise gain?

LM Datasheet(PDF) – TI store

Using the best heat sink possible. It is advisable to keep the output com. ESD rating to be datashfet. Depending on the load, this could be your problem. Sign up or log in Sign up using Google.

C, but if the temperature again begins to. The thermal requirements can become more difficult when.

Trim pot for max R OUT. Oscillations in voltage controlled current source Ask Question. In order to determine the appropriate heat sink for a given. A power amplifier’s output transistors can be damaged by. C for ambient temperatures up to.

This is a rather large heat sink and may not be practical in.

It starts operating again when the die temperature. Distributors for availability and specifications. Sign up using Email and Password. For a given magnitude. Assumes T A equal to 70?


C, the total junction-to-ambient thermal resistance must. C unless otherwise specified. The voltage applied to the amplifier is limited by the design of.

These are part of the internal circuitry of the LM, and. Try removing the cap and see what happens. When designing a printed circuit board layout, it is important.

The LM has a sophisticated thermal protection scheme. To answer your other questions: Offset Voltage Drift Versus Temperature.

Wide common mode range. Email Required, but never shown. The load does have a high TCR, and its resistance does increase but still stay within the ohm range. This will change the required heat sink to a.

The amplifier is also internally.